Results 1 to 2 of 2
  1. #1
    75+ Posting Member


    flyboy01's Avatar
    Join Date
    Jul 2008
    Location
    Newcastle, NSW, Australia
    Posts
    83
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    What does this message mean???

    Hi All,
    when i am flying a route, in cruize, after i pass a waypoint i get a message " waypoint above crz alt" it lasts for 5-10 seconds then goes off. What does this message mean and why does it appear?
    Any thoughts apprciated
    Trevor.

  2. #2
    Heli Builder
    Join Date
    May 2008
    Location
    Earth
    Posts
    288
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Quote Originally Posted by flyboy01 View Post
    Hi All,
    when i am flying a route, in cruize, after i pass a waypoint i get a message " waypoint above crz alt" it lasts for 5-10 seconds then goes off. What does this message mean and why does it appear?
    Any thoughts apprciated
    Trevor.
    On the Route page of your FMC what is the altitude next to the waypoint? Is it the same as your cruizing altitude or is it higher?

    Then some airways have an upper and lower limit. It is possible that the waypoint is only applicable to the route, therefore it has an upper and lower limit as well. Probably what the FMC is trying to tell you.
    Fritz -> Helicopter Cockpit Builder
    (FSX | TH2Go | Arduino | Air Manager Avionics | CNC)

Similar Threads

  1. MTR Button and FMC Message light
    By captdave in forum PM Boeing GC
    Replies: 2
    Last Post: 12-05-2010, 07:30 AM
  2. what is this error message
    By djcevera20 in forum I/O Interfacing Hardware and Software
    Replies: 0
    Last Post: 05-16-2009, 04:21 PM
  3. Message From The Vice President
    By Trevor Hale in forum MyCockpit News and Announcements
    Replies: 0
    Last Post: 04-23-2008, 08:42 AM
  4. Missing Message in CDU Scratchboard
    By flightdeck in forum PMSystems
    Replies: 4
    Last Post: 09-18-2007, 02:12 PM