calibration potentiometer on IO-CARD

[BOINET]

Hello,

I encounter a problem with the reglage with an analogical axis, I to affect an axis for
the ordering of the ailerons; when I launch the progamme "controlador" the axis ets recognized
well and when I operate the order, I obtiends a variation of 0 A 255 with a central
point around 132. I have write my lines in the program and then I launch FS9.
The order answers well but functions only of one dimension; if I turn the handle towards
the line, the ailerons function and the apparatus turns;
it leaves against does not keep its point medium and refuses to turn has left.
item 0 seems to correspond has what should be the point medium!!!
could somebody say to me what causes this decalage in the order and how resoudre the problem?
My second axis which corresponds has the elevator functions him about normally,
although the point medium seems too decale him.
I have to test various reglages, nothing made there.
I have to put the question about the Io-Card forum but like often, alas, no answer!!!

thank you in advance
excuse me for my bad english

Jean Luc

http://perso.orange.fr/b747project /

[Matt Olieman]

Sorry to hear your having a problem getting an answerer at their forum. I have a complete set of IO-cards and haven't had the chance to put them to use

BUT...

Regarding your problem... If I read the information right (lots of documentation over there, sometimes hard to figure out ) You use the FSUIPC... It is in the documentation somewhere....

I know... not much help.... at least an idea