02-26-2009, 05:40 AM #1
Wiring from pots to interface card
Greetings again. Quick few questions. When wiring from my pots in the throttle quadrant and yoke:
1) Is length of wire an issue? If so, what is max length I should use from throttle/yoke to interface card?
2) What type of wire should I use (as in...when I go to the electronics place, what kind of wire do I ask for)?
02-26-2009, 09:05 AM #2
As short as practical, but I wouldn't run them longer than 6-8'.
Ask for 22ga stranded copper wire.Boeing Skunk Works
Remember...140, 250, and REALLY FAST!
We don't need no stinkin' ETOPS!
Powered by FS9 & BOEING
02-26-2009, 11:54 AM #3
By AlexJ in forum I/O Interfacing Hardware and SoftwareReplies: 8Last Post: 05-11-2009, 02:53 AM
By AndyT in forum I/O Interfacing Hardware and SoftwareReplies: 1Last Post: 11-03-2008, 09:31 AM
By QF6228 in forum General Builder Questions All Aircraft TypesReplies: 0Last Post: 06-15-2008, 06:32 PM
By Kris Stow in forum I/O Interfacing Hardware and SoftwareReplies: 6Last Post: 03-13-2008, 04:39 PM