I have set up my PM sytem and it works just fine with my Flyengravity FW overhead panel.
But my respones from my HW is too slow, it takes about a 2-3 sec. when I Operate a switch and to the response from Pmsystem occures?(I have a screen setup so i see when the operation happens)
I have reduced the cycle to 60 on both places in the menu but still its to slow.
Any thoughts on this would be greatly appreciated.....
hi, some recomendations,
PM system will be on a good computer, and a good graphic card (medium)
NO dinamic Ip, static IP.
LAn, not wifi conection
same cable Lan for all comunications
disable on the PC all the recomendations of PM.
no 10/10 card lan, 100 in mode full dublex, (better 1000)
...only a few ideas...
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
my response is missing from yesterday so im replying again
TX a static ip did the job, now the response is as fast as the click from the switch
A happy new year to everyone!
happy new year