Thread: Chart board for 737NG
12-15-2008, 04:56 AM #1
Chart board for 737NG
I will make a chart board for my yoke and wonder if anyone knows about a printable pic of the text on the chart board. I will print to a plastic foil and glue it to a black alu plate fixed with a clip.
Top and bottom measurements (cm) of the plate would also be appreciated.
I will try to make a replica of this:
12-15-2008, 06:32 AM #2
measurements as follows
distance at top 85mm
distance at bottom 55mm
length taken from the middle 180mm
bear in mind that the unit has curved edges so the measurement is taken from the outside of the deges not the inside
12-15-2008, 07:12 AM #3
- Join Date
- Jun 2008
- Stafford, UK
12-15-2008, 07:23 AM #4
Thanks. I'll start cutting the alu plate after these mesurements.
The 737ng project page was of big interest, but a much larger project then mine. Sure I can pick up this and that from that site.
Still need a good pic of the text bit.
12-15-2008, 08:08 AM #5
12-15-2008, 08:23 AM #6
I've found them at aviationmegestore, but since I'm making my cockpit more or less by hand, I would also make this piece. It's done fearly easy I guess.
By skino in forum General Builder Questions All Aircraft TypesReplies: 2Last Post: 09-29-2010, 12:27 AM
By JWS in forum FS2004 Scenery DiscussionsReplies: 4Last Post: 01-08-2010, 04:45 PM
By Michael Carter in forum My Cockpit UpdateReplies: 6Last Post: 08-18-2008, 08:24 AM
By mpl330 in forum General Builder Questions All Aircraft TypesReplies: 17Last Post: 08-09-2008, 03:50 PM