Hi to all,

Finally I finished the hardware setup for my throttles using the below:

1 x phidgets 8/8/8 for pots, inputs and outputs
1 x advance servo 8 for the servos (throttles and spoiler)
1 x phidgets 0/0/4 for cutting the power of throttles and spoiler
1 x phidgets 0/0/2 for controlling the trim wheel from 8/8/8

I assigned and calibrated the offsets for manual move of throttles, flap and spoiler. (Works fine)
I assigned and calibrated the offsets for trim wheels (Works fine)

Now, I want to assign a logic to 0/0/4 for the throttles to work from the motor when A/T or TOGA is engaged. Please help.

Also I assigned a logic to 0/0/4 for the spoiler to work from the motor when armed and touchdown.

I did what the Configuring the Servo-Controller of circuit section of help file explained but a can not find who to check the servo contoller.

I am using the 4.3.8