Results 1 to 6 of 6
  1. #1
    300+ Forum Addict Rodney's Avatar
    Join Date
    Nov 2005
    Location
    Colorado Springs, CO USA
    Posts
    370
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Switching airframes from 737 to 727

    I am going to let go of my 737 modules to help finance my new 727 project. All prices are USD and shipping is NOT included.

    Digital TH2Go + 3 Acer 19" widescreen LCD Monitors (AL1916W) As a set only. $650

    FDS MCP $700

    FDS MFP $200

    OpenCockpits EFIS $115

    Bill Bulfer's 737 NG Cockpit companion $35

    FDS MIP, Non IBL, Populated and wired. Make me an offer.

    I put the TH2Go in the classifieds, but it hasn't been approved yet.

    Email, PM or ?
    Rodney -
    Real 727-200 pit
    Last Flown as N392PA
    FS9

  2. #2
    2000+ Poster - Never Leaves the Sim Michael Carter's Avatar
    Join Date
    Oct 2006
    Location
    Southern Illinois, USA
    Posts
    3,147
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    You have your site e-mail turned off, but to answer your question that you sent me, I'm using the DF727 flight model and FS Panel Studio to display the guages.

    A Leo Bodnar(sp) input card and a Hagstrom input card take care of the overhead and throttle quadrant, control yoke and autopilot. All indicators are mechanically lit as I don't have an output card yet. There are very few passive indicators I need lit so I've been putting it off for awhile to build my shell.

    Marker lights, windshear, GPWS, low oil pressure or filter bypass, DH, and flap in transit indicators is about all I really need the output card for. A few others could be wired as well, but that's small stuff.
    Boeing Skunk Works
    Remember...140, 250, and REALLY FAST!

    We don't need no stinkin' ETOPS!



    Powered by FS9 & BOEING

  3. #3
    300+ Forum Addict Rodney's Avatar
    Join Date
    Nov 2005
    Location
    Colorado Springs, CO USA
    Posts
    370
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thanks for that info Michael. I can't see in my profile where to turn email on/off at. My address is there. I'll get with admin.
    Rodney -
    Real 727-200 pit
    Last Flown as N392PA
    FS9

  4. #4
    1000+ Poster - Fantastic Contributor AndyT's Avatar
    Join Date
    Jun 2006
    Location
    Oahu, Hawaii
    Posts
    1,392
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    I'd hang on to the TH2Go and 3 19" monitors until you get the replacements for them.
    God's in command, I'm just the Pilot.
    http://www.geocities.com/andytulenko/

  5. #5
    Boeing 777 Builder


    Kennair's Avatar
    Join Date
    Jan 2007
    Location
    Perth, Western Australia
    Posts
    795
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    HI Rodney,

    I'm interested in your EFIS. I've sent you a PM.

    Cheers,

    Ken.
    Opencockpits | Aerosim Solutions | Sim-Avionics | P3D | FDS | FTX | AS16 | PPL | Kennair


  6. #6
    300+ Forum Addict Rodney's Avatar
    Join Date
    Nov 2005
    Location
    Colorado Springs, CO USA
    Posts
    370
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    PM's sent to the folks that asked.
    Rodney -
    Real 727-200 pit
    Last Flown as N392PA
    FS9

Similar Threads

  1. Airframes? Where to get them?
    By Jordan Farmer in forum General Builder Questions All Aircraft Types
    Replies: 2
    Last Post: 11-07-2010, 03:37 PM
  2. displays not switching
    By djcevera20 in forum OpenCockpits General Discussion
    Replies: 8
    Last Post: 06-22-2009, 11:19 PM
  3. ACT-ive page not switching by itself
    By eudoniga in forum PM Boeing FMC/CDU
    Replies: 1
    Last Post: 06-26-2008, 08:16 AM
  4. ACT-ive page not switching by itself
    By eudoniga in forum PM Airbus MCDU
    Replies: 0
    Last Post: 06-24-2008, 10:25 AM
  5. Using FS2Phidgets for switching between IAS and VS
    By Tomlin in forum FS2Phidget Users
    Replies: 2
    Last Post: 08-16-2007, 05:58 PM