Switching airframes from 737 to 727

[Rodney]

I am going to let go of my 737 modules to help finance my new 727 project. All prices are USD and shipping is NOT included.

Digital TH2Go + 3 Acer 19" widescreen LCD Monitors (AL1916W) As a set only. $650

FDS MCP $700

FDS MFP $200

OpenCockpits EFIS $115

Bill Bulfer's 737 NG Cockpit companion $35

FDS MIP, Non IBL, Populated and wired. Make me an offer.

I put the TH2Go in the classifieds, but it hasn't been approved yet.

Email, PM or ?

[Michael Carter]

You have your site e-mail turned off, but to answer your question that you sent me, I'm using the DF727 flight model and FS Panel Studio to display the guages.

A Leo Bodnar(sp) input card and a Hagstrom input card take care of the overhead and throttle quadrant, control yoke and autopilot. All indicators are mechanically lit as I don't have an output card yet. There are very few passive indicators I need lit so I've been putting it off for awhile to build my shell.

Marker lights, windshear, GPWS, low oil pressure or filter bypass, DH, and flap in transit indicators is about all I really need the output card for. A few others could be wired as well, but that's small stuff.

[Rodney]

Thanks for that info Michael. I can't see in my profile where to turn email on/off at. My address is there. I'll get with admin.

[AndyT]

I'd hang on to the TH2Go and 3 19" monitors until you get the replacements for them.

[Kennair]

HI Rodney,

I'm interested in your EFIS. I've sent you a PM.

Cheers,

Ken.

[Rodney]

PM's sent to the folks that asked.