Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. 08-17-2008, 02:23 PM #11
    ian@737ng.co.uk
    ian@737ng.co.uk is offline
    500+ This must be a daytime job
    Builder Of The Month / Point Value: 100
    Total Awards: 1
    Total Points: 100
    ian@737ng.co.uk's Avatar
    Join Date
    Jan 2006
    Location
    Oswestry, Shropshire
    Posts
    609
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    yes stef's right it was friday !

    yassoo maria....
    happy name day from me too..... xponia pola!
    rgds ... ian
    Mr. Ian. P. Sissons is hereby recognised as an Honorary Flight Sim Captain following his passing in February 2016. This is in recognition for his commitment to Flight Simulation.

    www.mycockpit.org Featured Builder August 2008 www.737ng.co.uk
    FS9/PROSIM737/CPFLIGHT/Lots of BU0836X's and a Beer Fridge
    Reply With Quote Reply With Quote
  2. 02-03-2011, 02:05 AM #12
    mabderezai
    mabderezai is offline
    10+ Posting Member
    Join Date
    Dec 2008
    Location
    California
    Posts
    18
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Rotary switches vs Encoders

    Hi ...
    I was wondering if anyone had a sample code for taking a rotary encoder directly into the mastercard... I am not use how one can avoid using an encoder card.

    Thanks!
    Mehdi
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Similar Threads

  1. Encoders and Rotary Switches
    By ozziesim in forum I/O Interfacing Hardware and Software
    Replies: 22
    Last Post: 11-13-2009, 01:21 AM
  2. Can you recommend some really thin / low profile Rotary encoders, switches etc
    By Nik_1988 in forum I/O Interfacing Hardware and Software
    Replies: 8
    Last Post: 01-17-2009, 07:12 AM
  3. Rotary encoders co-op
    By Paul G in forum Cockpit Parts and Motion Platforms
    Replies: 5
    Last Post: 06-02-2008, 06:08 AM