Results 1 to 2 of 2
  1. #1
    150+ Forum Groupie choffmann's Avatar
    Join Date
    Mar 2008
    Location
    Germany, Hanau
    Posts
    231
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Circuit breaker panels

    Hello fellow captains,

    I wonder if someone did a mockup of the 737(NG) circuit breaker panels for his pit? I am in preparation for it. I found some nice pics and diagrams of the P6 and P18 panels, but no measurements. From what I found, I would expect the width of the CB board on the F/O side should be about 95 cm, on the capt. side because of the jump seat about 55 cm, at floor level that is. But what about the measurements at the ceiling? Further: I donīt necessarily want to use real aircraft circuit breakers, because I fear they are quite expensive; so would you have suggestions what to use instead, which may be easily bought and fitted into an aluminium plate painted black? Anybody has ideas? I appreciate your help!

    Chris

  2. #2
    25+ Posting Member
    Join Date
    Jun 2008
    Location
    New Zealand
    Posts
    45
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Hello Chris

    Shoot me an e-mail - I think I have eveything you need.

    BTW - hop to the adds - you will see the some pictures

    Isaac

Similar Threads

  1. Overhead Panel Circuit Breaker
    By tlhflfsx in forum I/O Interfacing Hardware and Software
    Replies: 1
    Last Post: 04-07-2011, 04:43 PM
  2. Boeing 767 Overhead Breaker Panel
    By Michael Carter in forum Cockpit Parts and Motion Platforms
    Replies: 1
    Last Post: 08-13-2008, 12:46 PM
  3. Logic circuit
    By gokhotit in forum FS2Phidget Users
    Replies: 9
    Last Post: 09-24-2007, 12:49 AM
  4. How do you do Circuit and bumps
    By AndyH in forum Dodiano's Airbus Forum
    Replies: 5
    Last Post: 12-06-2005, 05:24 PM