05-21-2008, 08:42 PM #1
CP-Flight MCPEX: How to put Flaps on analog axis?
this is my problem: I own a CP-Flight MCPEX-Board, and would like to assign my flaps-lever to one of the analog inputs.
Unfortunately, this is not possible by default, as there is no corresponding command for this available within the MCP-software. (CP-Flight recommends the use of 9 micro-switches here.)
Now I would like to ask:
Has anyone here assigned the flaps handle to one of the analog inputs of the MCPEX and can give me some hints on
- creating / assigning the correspondig command
- setting the detents (9 for the B737)
Thank you very much!
Engravity, Project Magenta Full Boeing Software
By gspannelljr in forum I/O Interfacing Hardware and SoftwareReplies: 2Last Post: 03-18-2011, 07:13 AM
By Mr. Midnight in forum Computer Hardware SetupReplies: 7Last Post: 08-06-2010, 10:12 AM
By davemckee in forum General Builder Questions All Aircraft TypesReplies: 4Last Post: 05-07-2010, 05:36 PM
By zenandzen in forum Pilots Lounge - Let your Hair downReplies: 4Last Post: 06-12-2008, 04:34 AM