Results 1 to 3 of 3

Thread: Switch

  1. #1
    25+ Posting Member imported_767300's Avatar
    Join Date
    Aug 2005
    Location
    south florida
    Posts
    70
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Switch

    Hi there,anyone know if I can use a 2a 28volt pushbutton switch with these i/o cards?

  2. #2
    2000+ Poster - Never Leaves the Sim Michael Carter's Avatar
    Join Date
    Oct 2006
    Location
    Southern Illinois, USA
    Posts
    3,147
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Sure you can, as long as you don't exceed those maximums.

    I doubt you will using a third-party input card. Have at it.
    Boeing Skunk Works
    Remember...140, 250, and REALLY FAST!

    We don't need no stinkin' ETOPS!



    Powered by FS9 & BOEING

  3. #3
    25+ Posting Member imported_767300's Avatar
    Join Date
    Aug 2005
    Location
    south florida
    Posts
    70
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    switch

    Thanx for the reply BSW!!

Similar Threads

  1. On/Off switch with led
    By MicroHellas in forum Where to Start Building a Home Cockpit
    Replies: 10
    Last Post: 06-22-2010, 11:52 AM
  2. FDS K2 Switch
    By TR A321 in forum General Builder Questions All Aircraft Types
    Replies: 0
    Last Post: 04-03-2010, 04:40 AM
  3. GPS/Nav switch
    By Prarie Boy in forum General Aviation (GA) Builder Disccusion
    Replies: 2
    Last Post: 12-01-2009, 10:00 AM
  4. KVM switch
    By Jackpilot in forum I/O Interfacing and Hardware
    Replies: 5
    Last Post: 08-06-2009, 03:35 PM
  5. Avionics Master Switch vs. Avionics Switch???
    By Tomlin in forum I/O Interfacing Hardware and Software
    Replies: 4
    Last Post: 08-08-2008, 09:28 AM