Results 1 to 3 of 3
  1. #1
    25+ Posting Member mterm's Avatar
    Join Date
    Jan 2008
    Location
    New Hampshire USA
    Posts
    34
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    LED resistor placement

    Does the Location of the resistor in a LED circuit matter? Say you have a 5mm LED and it requires a 370 ohm 1/2 watt resistor. Does the resistor need to be placed at the LED's location or could it be placed further away say 2 to 3 feet from the LED at the power source. I am thinking of making a distribution block for the LEDs and locating the resistors there.

  2. #2
    2000+ Poster - Never Leaves the Sim Trevor Hale's Avatar
    Join Date
    Nov 2005
    Location
    Ontario, Canada
    Posts
    2,223
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Anywhere you see fit.

    Personally I like to place the resistor close to the device, but thats just personal preference.

    Trev
    ________________________
    Trevor Hale

  3. Thanks mterm thanked for this post
  4. #3
    300+ Forum Addict Shawn's Avatar
    Join Date
    Mar 2008
    Location
    Kamloops, British Columbia
    Posts
    425
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Quote Originally Posted by mterm View Post
    Does the Location of the resistor in a LED circuit matter? Say you have a 5mm LED and it requires a 370 ohm 1/2 watt resistor. Does the resistor need to be placed at the LED's location or could it be placed further away say 2 to 3 feet from the LED at the power source. I am thinking of making a distribution block for the LEDs and locating the resistors there.

    I've done exactly as you described and it worked great, simpler than soldering in a resistor for each led.

  5. Thanks mterm thanked for this post

Similar Threads

  1. MIP Placement
    By CessnaGuy in forum General Aviation (GA) Builder Disccusion
    Replies: 5
    Last Post: 10-23-2010, 04:44 PM
  2. FSBUS i/o card - resistor connect in series
    By adacho in forum I/O Interfacing and Hardware
    Replies: 2
    Last Post: 08-19-2010, 05:35 AM
  3. Level D 767 Gauge placement
    By Drewsta in forum Computer Hardware Setup
    Replies: 3
    Last Post: 08-06-2009, 09:01 AM
  4. Question about resistor heat
    By Paul G in forum Cockpit Parts and Motion Platforms
    Replies: 15
    Last Post: 09-04-2008, 05:04 AM
  5. Powering LED's : use a resistor or not?
    By shawnpwilson in forum Phidgets & Cockpit Simulator Builder
    Replies: 1
    Last Post: 01-18-2005, 06:21 AM