Re: Wall Mounted Projectors?
No, however I am eyeing the BenQ W1080ST, 0.7 TR, but it is a 1080p projector for ~ 1000 USD. I plan to use it for simulation -- flight and golf, and cinema.
Re: Wall Mounted Projectors?
Are you only using one projector? One of the problems with using three projectors is they have to sit on top of each other unless the throw ratio is less than ~0.7. I had two Optoma GT750E (0.72 TR), and ran some test setups, but I wasn't happy with the amount of warping necessary to align the images due to the inability to get the projectors close enough. I've read that some people have had success with similar projectors though, perhaps I'm too impatient!
Re: Wall Mounted Projectors?
We use three ultra short throw projectors on three flat surfaces. By testing we came to the conclusion that UST-projectors and curved screens is a very challenging combination. We were unable to get the focus satisfactory on a curved screen.
Re: Wall Mounted Projectors?
I'm going to try with one projector onto a corner wall. I know its not going to be 180 degrees, but we'll aim for one FSX view, zoomed out, so ~100-120 degrees, which should give a good enough effect.
Frames will be excellent, warping will be done with Immersive Display Lite 2.
Re: Wall Mounted Projectors?
http://unlabelled.de/userfiles/image...%20show/12.jpg
Obviously with a ST projector you will get a larger throw.
Re: Wall Mounted Projectors?
Oh, that's interesting. Have you found that the severe warping in the corner causes any distortion?
Re: Wall Mounted Projectors?
I use short throw projectors and they're definitely worth the investment.
All the best
Re: Wall Mounted Projectors?
Don't have a projector to test it out, but if you're going to be using a structural frame I don't think it will be an issue as it should be obstructed.