Upper and lower EICAS on same computer?
Dear all,
we like to use seperate monitors for upper and lower EICAS.
Our graphic card (nvidia 6600) supports dual monitor out for extended monitor view.
Is it possible to display both EICAS screens (each on one monitor) on one computer? Problems with OPENGL? If yes, how?
We tried it but it does not work. We started then 2 times the EICAS application which works (with problems).
Does somebody has experience with it.
Thank you very much for any hint.
Greetings Henning
Upper and lower EICAS on same computer?
Hi,
you can easily run the lower and upper EICAS on one computer with 2 monitors. Just run a second instance of the pm gc in a separate directory and select the desired page. I use SIOC for additional functionality of MFD selections. Works fine.
Best regards,
Rudiger
Re: Upper and lower EICAS on same computer?
Hi Folks,
i have another question.
We have now the both EICAS (lower/upper) System running on one PC (running two times the application in seperate directories).
Is it possible to seperate the page switching between lower and upper EICAS?
We just found in the PM FMC Software a public page select for EICAS. If we press it, then both (lower/upper) EICAS sreens will switch to next page.
Thank you in advance Henning
Re: Upper and lower EICAS on same computer?
as said above i have the eicas running in extended mode: one (1) instance of the software running both the upper and lower eicas.
With the cpflight mip737 board, the ENG and SYS buttons swap the correct pages.
Stef