FSUIPC Offset for Chrono

Hello Jean Luc,

i have tried to control the chrono via fsuipc. But unfortunately it seems as if the specific offset and the corresponding value do not work propperly:
I change 78E8 to 1 but the chrino does not start/stom. On the other hand, setting the offset to 2 or 3 starts or stops the ET Timer.
thanks a lot!

Markus

Hi Markus,

i have reviewed this. In my setup it works as it should, the Offset you give is correct. First button press is activating the chrono, second press stops and third press resets the chrono.

I use Linda to control this. Do you handle it in FSUIPC directly?

Regards,
Stephan

Hello Stefan,

I use FSUIPC directy. Maybe I should try using LINDA for that. The strange thing is, that the ET works propperly with the same Offset but different values handed over.

regards

markus

Ah I found the mistake: try using offset 0x78ED, 19

Regards, Stephan

Thank you

but neverthless, the 78E8 should start the chrono of the clock (standby instruments) - or did i misunderstand something?

Regards

Markus

Maybe JL can reply after his holiday, if this was either a mistake or wanted as it is.

Hi,

I'll try to check that tonight.

Regards,
JL

Hi,

I tried the 78ED offset with value 19. it worked for me??

Regards,
JL

Oups sorry, yes indeed 78ED works with value 19 (CPT CHRONO), even though it mistakenly also triggers the MIP CHRONO.
And 78E8 with value 1 does not work. I'll correct that.

JL

Thank you

Regards

markus