Re: drawings & dimensions
First welcome to the forum..
Depending on the version of the 737 you are inquiring about (there are several) you may find this site .. Another builder quite helpfull
http://users.skynet.be/jcordon/cockpit/plans.htm
Cheers
Ron
Re: drawings & dimensions
I have sent Juan the owner of the site a PM. as all the dimensions were not on the site, Thanks Jack
Re: drawings & dimensions
Jack,
Probably of help my tutorial on panel dimensions on the frontpage of this Mycockpit site at this time.
If you draw/make the panels at the inner side correct, in fact after that, the dimensions of the whole assembly / outer dimensions (e.g. pedestal) do follow logically from these inner dimensions.
Since we all make small errors with dimensions, following this method (from inner to outer) makes fitting of the final outer housing more accurate in your specific situation.
Hope this helps,
Hessel Oosten
Re: drawings & dimensions
Hessel, bedankt. Ik ga meteen kijken,
groeten vanuit een warm Frankrijk :-)