I have about 50 of these that I bought some time ago. No data sheet but this is what they look like.
http://www.bourns.com/data/global/pdfs/PEC12.pdf
Can they be used with FSBus.
David
Printable View
I have about 50 of these that I bought some time ago. No data sheet but this is what they look like.
http://www.bourns.com/data/global/pdfs/PEC12.pdf
Can they be used with FSBus.
David
hi,
they look good, but try it.
Stefan
Hi Stefan,
I have tried them but I am not getting what should happen as in the instructions.
Tried all things with them but I just get 1's and 0's. No -1's
I have followed the tutorial in the manual 100% but I must be missing something.
I have put all the gauges back into the sim and I am going to fly for a while and then do some more coding.
Appreciate any help you can offer with these encoders though.
Thanks
David
I followed Dirks instructions. I used flat cable, pin 1 to first wire, pin 2 second wire, pin 3 to third wire. (then I tried all variations of this ie: wire 1 to pin 2 etc)
Plugged it into port 20 or position 20 as it has to start on a even number, and in FSAdmin, Set key 20 to Phase A type rotary (infact, I tried all the types type b, BCD, even Greyhill even tried setting 20 and then 21 to type A, type B etc) they all did exactly the same thing ie:
20 1
20 0
21 0
21 1
Did you set the jumper for configuration?
IO-Docu on Page 18.
"Set J16 jumper on the IO board. Change to Set CID tab and set the
desired controller ID."
Yes. Every change on a FSBUS board (Display not) need to set the config jumper.