-
Problem with cards
Hello,
I Placed following post on the opencockpits site but did not receive any response. Someone can answer my question?
----
Hello,
I have a problem with my connection:
My setup is as follows:
- PC to USB expansion card
- Expansion card port J1 with official parallel cable to master card
- Master card with cable from J3 to inputs card with the encoders on it.
I configured the INI files.
When I start Controlador, and push start, I see in input:
000-001-002-003-004-005-006-007-
Sometimes it just flashes all types of inputs and after some seconds, it stops with some values, later it starts switching again.
When I disconnect the inputs card from the mastercard, the inputs table stays clear.
The manual says it is wrong when something is shown on the input screen while started.
I haven't connected anything to my inputs card.
Is my inputs card broke or am I doing something wrong?
Thanks!
-
Re: Problem with cards
Hello,
I recently had the same kind of problem, you can view the thread here http://www.mycockpit.org/forums/showthread.php?t=17400
My cards are currently shipped to OC for checking, they should be there tomorrow. As soon as I get them back or as soon as I have some news I'll update the above thread with the answer from OC.
Kind regards,
Wendy