Cockpitsonic Breakout Board Wiring

Hi Folks,

Does anyone have a wiring diagram for the Cockpitsonic breakout board, I recently purchased a landing gear lever and the BOB came with it, I thought I might utilise it to wire up my recently delivered symulatory MIP, any suggestions??

I'm not sure if you just wire it all up then assign the correct devices in the .ini file or if each input has it's own allocation on the board.

I have downloaded the pdf's from the cockpitsonic site as well as the driver but the BOB diagram is based on the pre-wired cockpitsonic MIP and is setup by colour coded wires.

Any advice / Help would be appreciated.

thanks

Dave

I suggest, you send a mail to cockpitsonic directly!
Mathias is very helpful and normally it is a matter of hours to get an answer!
Cheers
René