APU Procedure stops at "Flap open"
Hello guys!
I installed the FS X, the Jeehell-Soft and an configure a throttle and a joystick!
After this i start the "StarterFSX".
Everything is working until the position "APU-Start".
After i start the APU with "APU-Master" after this "APU-Start".
I see on the SD the APU page. I see the message "Flap open" but the "N" and "EGT" are not starting.
I hope anyone know the problem why the APU-procedure stops!
regards
Peter
Re: APU Procedure stops at "Flap open"
Hi,
You did not pause FSX?
Regards,
JL
Re: APU Procedure stops at "Flap open"
hello jl!
No not paused!
regards peter
Re: APU Procedure stops at "Flap open"
Did you start the ab flyby wire exe (can't remember the exact file name)?
Re: APU Procedure stops at "Flap open"
Hello guys!
I found the problem!
At first i had to say i installed all Soft (FSX an Jeehell) on one Laptop for a test configuration.
And the problem of this Laptop is, that i see the last line of the fsx-window not!
So the cracks know whats happend :-))
I forgot to unmark at the FSX config that he "pause" if i leave the fsx window!
After this my software is working (means the apu starts and the start-button shows "avail" etc.)
Thanks for helping anyone!
regards peter