Rotarty Encoder issue

Hi all

I have an issue with my rotary encoders and not sure whats going on:oops:

I have hooked up Rotary encoder CTS 288 model 288T232R161A2 to B32 on Leo's BU0836X board.
Middle pin is connected to Gnd on the board , left pin is connected to B32
right is connected to B31

I went into game controllers to check to make sure they are working.
Rotated the encoder to the right and switch 32 lights up but if I keep turning to the right, 31 lights up. Turn the encoder to the left 31 lights up, but keep turning to the left 31 lights up
Is that normal:roll:

Cheers

Rhys

that is normal if you have not used the "encoders.exe" that is on Leo's site, there you set the encoder to the 31/32 input pair. then it will work normal.

Andy

Here is a link:

http://www.leobodnar.com/products/BU...6_encoders.exe

Thanks Guys,

As Homer Simpson Would Say - Duh, my mistake, :oops: had the second output wire connected the to the B32 Gnd connection.

Hey Reid, did Pete get round to doing a program to handle as many rotaries as you wish

Cheers
Rhys

He is on vacation until the 1st, so on hold until then.

Reid