BU836X Bodnar Card Problem
I fired up the sim this morning for a flight and found that at least two thirds of the programmed functions in the overhead are no longer working.
FSUIPC does not recognize most of the switches that are hooked up to the card including pnuematic starters, beacon, taxi and runway lights, heading bug, OBS, pitot heat, and strobe lights among others.
What is working are the yaw dampers, nav lights, no smoking and fasten seat belt switches. That's it.
In addition, as soon as the aircraft loads, all three pnuematic starters start by themselves and there is no way to stop it either with a keyboard command or a physical command.
When loading the default Cessna at Seattle, the engine is attempting to start with the mixture pulled all the way back and the mags in the 'on' position.
The magneto switch cannot be turned to any position using the mouse or keyboard commands. I find this very strange.
Why would most of the inputs on this card just stop working for no reason and then exhibit the strange behavior with the default Cessna upon FS startup?
Not one thing has changed since the last shutdown.
Assignments remain the same throughout the FS assignments page, all devices are on and recognized, but the card seems to be bad.
Does anyone have a clue about what could be happening or have happened?
My 727 is grounded.