-
Display bezels 737
Hello,
It's been a while since I last posted some results. Today I show you the display bezels that I have made, of course with my CNC.
Still missing the big screw on the right hand corner. Here is the picture.
Regards, Wendy
http://www.querit.eu/FS/Finished_Bezel.jpg
-
Re: Display bezels 737
wow that looks top-notch! great Job!
-
Re: Display bezels 737
-
Re: Display bezels 737
great job wendy !
you amaze me every time you post your work !
Stef
-
Re: Display bezels 737
Wendy,
Great job on the bezels, in case you're interested you can use the PC case closing screws, which have the knurled section in place the large screws you are missing. They're available from Maplins for just a couple of pence.
regards
Joe.
-
Re: Display bezels 737
Awesome job. You must spend hours drawing and then cutting.
Milt
-
Re: Display bezels 737
@Milt
The most difficult part was how to get the strange curve in the bottom corners correct. That took me weeks to think how to do it. Finally, when I started cutting, it was easy.
A lot of work is sanding the MDF, painting and sanding again and painting...
@Joe
Thanks for the tip
Thanks for the nice comments
Regards, Wendy
-
Re: Display bezels 737
WOW , that looks awesome ..... if ever you set up a webshop and start selling (these) parts let me know!! :)
-
Re: Display bezels 737
Hi Wendy,
I found these on eBay, they may be what you're looking for....
Regards
Joe.
http://cgi.ebay.co.uk/Akasa-Coarse-T...d#ht_545wt_958
-
Re: Display bezels 737
Hi Wendy,
Nice job!!!
Can you explain how you made the corners at the bottom side?
And do you have measurements of the bezels?
Best regards
Jan Geurtsen