Goflight throttle RMK

Guys im being driven up the wall here by my Go-flight card.

I am using the goflight rmktq6 card (throttles card) and when i connect my pots to the card and assign the relevant throttles in the goflight program. I have made sure there are no conflicts in the flightsim by removing all assignments of the card from fs and the yokes etc.

When i then use the throttles in FS all **** happens and the control surfaces of the sim just move when i move the throttles even though there is no way of them being programmed by the card?

Im lost completly lost any help?

Rhys,

I don't have Go Flight Throttles but have you checked assignments of other Joysticks within FS might be making conflict with the GO-Flight module? Try erasing all Joystick assignments for all devices first and Configure your Go Flight module then the rest!

Regards,

Roberto

Make sure you check FSUIPC, FS assignments, goflight config wizard as well as any other key assignments in other softwares you may have for any conflicts. As well as this check the sensitivities of the pots and make sure you have run a calibration in fs assignments.

Try all that and see what happens.