Servo going from 0 to 180 w/out stopping
Hello,
My servo is traveling the 0-180 range without stopping in between. :eek:
I'm using a USB servo controller card and have connected the HS-322 servo to the SimKit VSI gauge. When the VSI needle in FS2004 crosses above the zero line, my servo goes to the upper end. And when the needle in FS re-crosses the zero line (to the down side), the servo comes from its end position and goes to the opposite end position without a hint of stopping in between.
Any ideas on how to solve this?
Cheers,
Obi-One