You guys won't believe this. Please have a read.
I got to thinking awhile ago about the 12" monitor problem I'm having. If you haven't been following along, I needed a 12" monitor for my 727 engine gauge stack. So I buy an ELO touchscreen thinking I can integrate this into the panel with a bit of fussing & cussing.
I didn't realize the video problems were going to be worse than the hardware problems.
For days on end I've been trying to figure out how to get a 600x800 portrait display out of this monitor. FS sees it as a widescreen when orientation is rotated 90° and there is no available resolution that the monitor will support.
Just now, I opened the FS configuration file, forced the resolution to 600x800, and crossed my fingers.
After firing up FS and undocking the engine display I created in Panel Studio it works. It finally works! I can't believe I didn't think of forcing the resolution through the .cfg file. This was my last trick. If this hadn't worked I'm not sure which direction I would have taken.
Well, if anyone else has to do this I hope this helps.
Now I just have to refine and align the gauges after I disassemble and nount the screen behind the panel
http://i63.photobucket.com/albums/h1...nestack003.jpg