Hello Henrik,
This is described ine the B50.0 Installation Guide...
>>> Chapter 3.3 + picture page 14,
>>> Chapter 4.1 from page 16 to 18,
>>> Chapter 4.3 about Simconnect.
Best regards,
Michel
Printable View
Hello Henrik,
This is described ine the B50.0 Installation Guide...
>>> Chapter 3.3 + picture page 14,
>>> Chapter 4.1 from page 16 to 18,
>>> Chapter 4.3 about Simconnect.
Best regards,
Michel
And install Skalarki Profiler on P3D PC (Skalarki needs FSUIPC) and connect hardware on this PC.
Maybe it works on another PC through WideFs, but I think "the fewer network exchanges, the better" ;-)
Michel
Hello guys,
thank you very much for your tips and your help. I got it working now, only Master Sound and Intercom is running on the P3D-PC.
I also considered to move IO-Profiler to the P3D-PC, but this worked in the past very good on remote-PC.
One tip for all people having issues with USB. Always avoid to produce Hub-cascades, always connect an external hub to a direct port of the USB-Controller, not to an internal hub-port. You can perfectly check this with the USB Device Treeviewer, and reconnect to have an optimal result.
For example, the dongle of ImmersiveDisplay needs to be the first device on an controller, otherwise it will disconnect and reconnect again and again.
Best regards
Henrik
Hello. Anybody uses hardware from POLIDRANOGET? after installing JH B50. the driver of this software stop working sometimes, and i can not use modules( overhead; ECAMS; autobrakes, etc). Anybody uses hardware from this brand?
regards
Frederico
Can anyone pls advise how to fix hardwareconnect.exe crashing.
Have installed v50 twice with all correct software with same outcome.
Thanks
Michael
Pc1 is running just fsx and pc2 is running skalarki, sioc card and fds card and all controls (which have been configured thru temote joy). So thats all im installing.
Something i have noticed is in the configure.exe is the box for "computer running fmgs server" will not stay checked on the fsx pc.
The configure.exe issue is not causing any hard crash. As long as you re-tick the correct boxes before clicking to validate, this is a non issue.
Regarding the hardware crash, try to remove the remote joy function at first (so remove the remotejoy.dll).
if it still crash, remove all the DLLs, then put them back one by one until you find the issue.