Hello,
I have GC PM, and ND panel, sometimes it is showed all complete circle (360°), sometimes it is showed only upper, i must set any config ?
Thank you.
Printable View
Hello,
I have GC PM, and ND panel, sometimes it is showed all complete circle (360°), sometimes it is showed only upper, i must set any config ?
Thank you.
What do you mean exactly?
I think that you are needing to switch from "Rose" (circle) to "Arc" (half circle) modes on the EFIS to change these displays. I use Ellie Avionics Systems glass so I don't know the PM setup....but if you have it hardwired to the EFIS panel.... look for Arc and Rose mode there.
best,
................john
In that case toggle the key "C" (US keyboard)