Try this:
http://flightsystem.wix.com/airbus#!resources/cisa
in FMGS 3rd party Plugins/Addons
Printable View
Try this:
http://flightsystem.wix.com/airbus#!resources/cisa
in FMGS 3rd party Plugins/Addons
Hello JL,
are there any news about a coming update? Any estimate? Just asking cause of trim wheels bug....
Thanks a Lot
#
Regards Marco
Hi JL -- with FMGS configure it is possible to set a null zone at the detents for the throttle lever (idle, climb, flex, toga, etc). However on manual flying (auto thrust disconnect) and controlling the thrust of the aircraft, I notice the power will move back and forth (although thrust is set at one setting) -- this is because the axis of the joystick card -- Leo Bodnar is very sensitive.
Is it possible to also set a null zone when using manual thrust?
Thank you.
Ben
Hi ben,
No it is not possible, it would induce too much issues I think.
Regards,
JL
Hi Ben,
which potis u use? 10K 100K?
Maybe changing potis would help?
So do a test and connect 1 or 2 10k potis to to card and use them for the throttel. I am using 10k potis with this card for dimming displays and dont have these issues.
How old is the throttle? I had have a view months ago some problems with 10k poti of an jostick. Same problems u discribed. So maybe the poti of your TQ is damaged.
Hope this would help you to determine where the problem is.
Regards Marco
I think I will leave it as it is. There are only mild aberrations (noise). I do not want to cut the original pot wires and would prefer to leave it as it is as I am directly wiring to the canon plugs.
Dear
is there offset for rudder trim ?
One week radio silence...
JL gone for vacation, or something BIG is getting ready... I hope the 2nd one :lol:
Regards