Printable View
Hi! I am about to let a copy shop print my Annunciators onto Plexi, but I'm not exactly sure how big they are. Am I right if I say there are:
1*2,5cm (gear, flaps, g/s pinhibit etc.) (those are the ones i need most of also alot on the overhead)
1,5*1,5cm (A/P P/rst, Stab out of trim etc.)
2*2cm (Master Caution, Fire
2,5*2,5cm (FLT CONT IRS FUEL, etc.)
thanks alot! cheers
They are certainly within a millimetre or two at most, if that's ok with you.
I would question the last one though @2,5*2,5cm. The real one is double the width, 2,5*5cm. Were you planning on splitting it into two?
Sean
ah ok, as a test i did 11*24 mm for the first one (look at my other thread)
but you're right with the last one: i thought they were two different units - that's how i'll do it ;D
looks awesome with the method i'm using!
mrmaster