Interfacing

To start with I just want to say hello to you all,I have been building on my 737ng project for 2 yrs with a short break(6 month) when I joined swedish army and went down to Kosovo as a Fn-soldier(did it to earn money so I could buy new products for my cockpit).

Ok now for the question.

I have the FDS SYS3 card for my MIP, a few days ago I orderd a complete built TQ from simparts with Phidgets interfacing, am wondering if it`s possible to use Phidgets cards just for the TQ and the SYS3 for the MIP, or will the cards software counteract each other?

Am a really newbie with interfacing.

Regards

Should not be a problem. I have used multiple interfaces in the past without too much trouble. Probably take a bit of setup.

Thanx Bob,good to hear that I don`t have to switch the entire setup to Phidgets.

Regards