Hello
I just added in my MCP on the bank angle selector
I use the offset 552A to place the value 10-15-20-25 or 30.
But this does not change the angle of the plane rottation in HDGSEL mode.
Can you help me?
Thanks
Printable View
Hello
I just added in my MCP on the bank angle selector
I use the offset 552A to place the value 10-15-20-25 or 30.
But this does not change the angle of the plane rottation in HDGSEL mode.
Can you help me?
Thanks
Hi,
The official offset is 2E04 4 in deggrees.
But note that this works only for FSX and only for default airplanes. Not the payware like PMDG.
Hello and thank you for your quick response.
I changed my programe (SiOC) to send the values (10-15-20-25-30) in offset $2E04 (length 4) but, in FSX with a standard aircraft, no change.
For my test I am at an altitude of 11,000 and in HDGSEL mode. I change the heading of the aircraft and i trying different angles.
Do you have any idea why ?
Can you tell me where to find the list of new offsets to date because I did not this offset in my list?
I went see your site, your cockpit is very impressive. Thank you help.
Sincerely
Hello,
Nobody for my help ?
Hi there,
Try Offset $2EF0. This controls the Flight Director Bank Angle. It might not work but just a shot. It has a Length of 8 Bytes and is written as a Double Floating Point format.
Jack
Wsixpo
I assume that you are using Project Magenta as you have posted on this forum, in which case the offset 552A appears to be correct. The other FSUIPC offsets that have been quoted are documented by Peter Dowson as not being able to be written to in FSX - so they will not work in your example. Assuming you are using PM are you sure that your SIOC coding is correct?
Regards
David
Thank you for your help.
I'll try that and check my code.
For the PM part we work with MCP, CDU, GC, Whazzup. We have not yet PMSystem