Trim Indicator and FS2Phidget

I have a question... I am going to use 2 Hitec HS-55 servos to drive the trim indicators on my 737 quadrant. Does anybody know if the FS2phidget allows you to assign 2 servos on the 4 servo Phidget card the same assignment.

Thanks
Mark

Hello,

you can use a so called Y-cable to link the servos on one channel. You just have to look that you install the servos in the same direction. I'm normally using the end step on each servo and then installing them. It works fine.

regards Jörg