Hey friends,
first of all I want to say thank you to this forum because I found a lot of interessting things here... ;)
Now to my question :)
I have here two orginial dual encoders (Gables) of a real aircraft and some other switches. The switches works fine but my encoders does not.
My main problem ist, that I don't have a datasheet so I dont know which pin is ground and which pin is the actual button.
The only thing what is to see on the encoder are the two shafts and a flat cable in rainbow colors (7 cables). At the end is a little box and at the bottom are 8 pins, 4 short pins and 4 long pins. I think that every direction has one pin + one ground for each encoder. (two encoders + two directions = 8 pins)
Sorry for my "bad" description but I don't know how I should describe the encoder better. For information, the encoder rotary was installed on a COM Panel.
I hope you can help me, so I can use them on my little project ;)
PS: I use the BU0836X card and plan to realize the COM Panel in the FS. This should be 4 buttons of the card...
So far, IÄm looking forward to your answers ;)
Benjamin
If you have questions, I hope I can answer them.