For those that have disassembled a monitor...
I have everything out of the case, but it looked like a lot of those screws may have been grounding the controller board, and the input board, as well as the monitor to the metal chassis.
When you disassembled your monitor(s) did you have to re-ground everything, or is this something I don't have to worry about?
I didn't see anything specifically marked 'Ground', but you never know.
I haven't fired it up yet because I can't find my roll of foam tape to mount the controller board and the inverter board to the back of the monitor.
This is going to stick over to the right so far into the next panel I could darn near get the flap gauges out of it too, but it's not enough screen.