Am i going crazy!!!????

Printable View

02-24-2007, 04:38 PM
bindook

Am i going crazy!!!????

For the last 4hrs i have been trying to connect a 4 pole 3 position rotory switch to the A320 engine start panel. (Crank, Mode normal & ign/start). I have gone thru about 10 of these rotories & all of them do not show up the no.2 position when i turn it from no.1 or no.3. But when i have a look at the controler page (SIOC) the switch numbers actually appear!!!

Could anyone please explain why this is happening??? As i am about to self destruct ;-) Or can i programme the 3 positions only using the 1 & 3 position????

Thanks
Michael
02-24-2007, 04:43 PM
Bob Reed

What type of switch do you have it setup as?
02-24-2007, 05:24 PM
bindook

Rotary Switch 4 Pole 3 Position 1 Gang ????
02-24-2007, 05:27 PM
Bob Reed

What I mean is, don't you have to define the switch in the software? I would think so.
02-24-2007, 05:43 PM
bindook

I have just connected a push button up to the wiring & it is ok but the funny thing is when i then turn the rotary switch the middle switch shows up once then never comes back only the left & right numbers appear......this is weird...it's like i'm not meant to finish the sim!!!!!
02-24-2007, 05:58 PM
brianwilliamson

Michael............first check with a multimeter that your centre pole is going to each of the three output poles. That is the first thing to make sure you are getting each pole switch to go through your middle pole. The SIOC I am not familiar with at this stage, but it is very good I believe. You could program the 2 switches and when in the third position you could have no contact and program that in the NORM position.
Regards................Brian W.
02-24-2007, 06:03 PM
bindook

Hi Brian,
but should i have this problem on ALL the rotary switches i tried??? It seems a bit strange........i will look into your suggestion with the programming.....

Thanks
Michael
02-24-2007, 06:12 PM
brianwilliamson

If there is one pole not connecting when you check it with a multimeter, then it is a faulty switch. It seems highly unlikey that this would happen on one let alone a number of them, but let the multimeter tell you the story.
Cheers.........Brian W.
03-03-2007, 01:45 AM
AndyT

I have to agree. Get the meter out and test the switch. Test ALL the positions, and continiuty test across positions for shorts.
03-22-2007, 06:20 AM
Hans Krohn

Are we talking about a mechanical rotary (usually 12 pos), or about a rotary encoder? It you use the latter, make sure it is a brand / type that is recognized by OpenCockpit's hardware. They sell their onw rotaries, and they are connected to their master cards almost like a regular push or toggle switch (but using 2 leads).

Hans