Cannot read value from JeeHell by fsuipc offset

Hello everyone.
This my first post.I have question about how to read value from JeeHell this difference from PMDG? Usually I use Link2fs for read offset to check value but I cannot read any value from offset JeeHell.What I do wrong? Need to config? Please advise to me.

Thank you.

Quote:

---

Originally Posted by tonpp

Hello everyone.
This my first post.I have question about how to read value from JeeHell this difference from PMDG? Usually I use Link2fs for read offset to check value but I cannot read any value from offset JeeHell.What I do wrong? Need to config? Please advise to me.

Thank you.

---

Attachment 10195
I try to open FSUIPC Connect this show "Not compatible with FSX/P3D......"

Did you run configure.exe (tick This computer is running FS9/X), and then StarterFSX.exe?

Quote:

---

Originally Posted by OmniAtlas

Did you run configure.exe (tick This computer is running FS9/X), and then StarterFSX.exe?

---

This my step after open computer
1.Open MSFX and select JH A320.
2.Go to C:\A320FMGS and open configure.exe and select This computer is running FS9/X.
3.StarterFSX.exe
4.Go to C:\A320FMGS\FMGS Server and open FSUIPCconnect.exe but same result.
Is this correct step.

Thank you JeeHell for your support.

FSUIPCconnect is not used to have FSUIPC hardware controls. You must not use that with FSX/P3D
You just have to install FSUIPC supprot during installation. Then, starterFSX will launch hardwareConnect which adds the FSUIPC support.


regards,
JL