Not much to look at but i have finally started the throttle.
I shall keep posting as i progress. Got the Dividing walls (?) cut out and the centre spindle ready to take the throttle levers which were very very kindly donated to me by Jackpilot.
Once i source all the components i need and take the advise of a fellow member on here about covering with plastic i should have a very good TQ.
http://i204.photobucket.com/albums/b...cture016-1.jpg
http://i204.photobucket.com/albums/b...Picture029.jpg
I shall go to a little machine shop i know tomorrow and see if i can have the little detent arc made up from aluminium for the flaps lever.