Printable View
hi guys:
i have one problem, when i start my 737 all is ok but IRS allign cascade fault in prosim737 failures page... if i reset it from FMC and delete, all displays begin to work, I think I´m doing everything OK, any sugestion??
SISMO MIP and OVHD, prosim737 and RSP throttle
Aitor
Are you moving the aircraft before the IRS is alinged? Takes about 10 minutes.
no, i dont move it
I must admit that I not am good friends with the alignment process in Prosim. So often I end up resetting the failure in the Instructor Station.
My answer before was written from my phone, hence the shortness.
The alignment process is a rather lengthy one: From the B738 FCOM "Alignment time varies from five minutes to seventeen minutes depending on airplane latitude".
Three ways out of this:
If you start in "Cold & Dark" then make sure to do the alignment-proces in the right order.
Start in Ready-state. Then it should not be an issue.
Just delete them via the FMC.
I recommend you head over to the Prosim-forum. Lot of helpful guys overthere.
thanks Peter, will do..
nice flights!
Aitor