Printable View
Hi all, so I've placed an order for the Skalarki MCDU -- http://www.skalarki-electronics.eu/e...etail?Itemid=0
Those that have the device -- does it come with its own power supply? It is not very clear on the website if it does.
I am assuming I may have to power the device with both a 12 V DC and 5 V DC?
Thank you.
I'm pretty sure you have to buy the power supplies separate! - I've doctored a standard PC (ATX) power supply, that way you can use both a 12v and 5v feed directly from the ATX PSU :) - That is probably the cheapest way to supply the MDCU with power, Marcin does sell 5v, 12v and 24v PSU's on his site though also :)
Cheers,
Bobby
For CockpitSonic items, I was also advised to hook into a standard ATX powersupply, which I have done.
One question: Can you actually use a PSU without it being connected to a Motherboard. Not sure if the MB is needed to turn on all or if the full circuit is powered after pressing the ON button on the PSU...
Yep, just connect the Green wire from the PSU to one of the black wires the PSU will then be 'always on'Quote:
Originally Posted by SSO
I converted one of My PSU's last weekend, see my post: http://a320project.bobbyallen.me/201...ew-other-bits/
As you can see from the photo I have added a couple of terminals (the green terminals) with the red wire attached so that once my cockpit is complete I can add a toggle switch to turn it on remotely but if you don't want to do that just (and like I say previously) just connect the green wire to one of the black wires :) - No motherboard required :D
Hi thanks guys, power supply setup seems complicated, and probably something I will tackle when I need to power up the rest of the pedestal.
In the mean time can I use one of these?
http://www.ebay.com.au/itm/AU-Plug-t...6da8ddf&_uhb=1
Do you need to wire the input to the mcdu or does it come with input plugs?
Is 2A adequate to drive the MCDU?
And for the back lighting (5V) I assume there is a separate power input and I will therefore need another power supply.
I dont quite see why you would need a separate PSU.
Just pull some wires from your FSPC via the old type 4 leg connector. There you have both 5V, 12V, and GND.
Thanks SSO...I like to keep my computer organized, perhaps I will purchase a 300W (sufficient?) ATX for the pedestal.
I don't the ins and outs of the PSU...will prob need all your help when the MCDU finally comes (long wait time).
Thanks again.
Found this!
https://www.youtube.com/watch?v=m4uRnID7G_Q
I have an old Skalarki MCDU and it have only one connector for 5v power.
are you sure mcdu need double power ?
The newer skalarki MCDU is backlit and requires 2v.Quote:
Originally Posted by asessa