Hi
Could anybody tell me where I could purchase front gauge rings to trim a panel with the gauges displayed behind on a 19 inch monitor.
Thanks
Steve
Printable View
Hi
Could anybody tell me where I could purchase front gauge rings to trim a panel with the gauges displayed behind on a 19 inch monitor.
Thanks
Steve
How much can they cost ?
I just ordered black PE 300 HD sheet 10mm thick to try CNC machine it ;)
Hope to get the sheet next week...
I need some about 15mm deep to allow room for a rotary encoder behind.
Steve.
Ps my Garmin is almost done!!
Just buy a broken gauge from ebay, take off the bezel and make a mold using clay. Fill the mould with silicone and add a little hardner and you can make hundreds of the little fellas.
Or use the ends of party cups. Wilkinson's sells party cups with a very convenient measurement of 79mm dia. Just cut the last 10mm -15mm off each cup, then prime and paint. I done this when building my Cessna 172 and got some 79mm dia clear discs made which I inserted in each one to give the effect of a real gauge.
See picture:
http://alexpilot.50g.com/images/5b.JPG
cheers Alex, I will check this idea out, was thinking the same today when I got a coffee from the vending machine.
Thanks
Steve
isn't 15mm too deep to see the gauges unless your eyeline is directly in front of each gauge? I took the front bezel off of my monitor to allow me to put the panel flush against it so the gauges aren't obscured by the panel.
John
10-15mm too deep?.......... Probably! (Was just using this as an example!)
Cut off rings at however deep your MIP is.......
Mine were actually around 2-3mm deep, just cut to however deep you want it!