Re: continuous nick movement
hi michael!
i never ecperienced this behaviour neither other users i suppose...so this sounds like a local issue.
some more infos are needed to understand where it comes from, some questions may seem silly or obvious but better to clarify from the basis:
- are u using JL aircraft provided during installation?
- did u configure ALL the flight controls axis and ALL thrust levers detents in FMGS? and removed all flight controls assignments in FS and fsuipc?
- did u program all the required (red boxed) fields in mcdu during preflight including INIT B page?
- which modes were annunciated on the FMA when experiencing the problem?
bye for now
filippo
Re: continuous nick movement
Hi Filippo,
thanks for your reply ! The answers to your questions are all "yes". However I found my mistake. On INIT PAGE B I used the UPLINK function to get the standard values and then I changed the Block Value to 6.8 because i was used to it in most of my flights with the Aersosoft AXE. I think the system was confused and tried to trim all the time ? I guess this was the reason for the oscillation.
I checked it right now again with the standard and correct values and my flight is absolutely normal.
Thanks and best regards
Michael
Re: continuous nick movement
great u solved!
yes that was the reason: the function of the uplink feature is to load weights directly from the sim so if u use it u should never touch the entered GW because it's coming directly from the actual aircraft load.
cheers
fi