To Alan : TQ working great, just need slower servo speed

Thanks for your great program.
My motorized tq is working great with the latest v4 ( nov 13 )

The only thing I cannot achieve is a slower servo speed.
I have the servo speed set at 1 degree/sec but the speed is much faster.
In Fs itself the levers also move too fast, but I thought it could be modified in the program.
Is there something I can do ?

Thanks in advance.

The servo speed setting should slow servo down. Sounds like is not working properly. Let me check that and get back to you.

Regards,
Alan

That would be very kind of you Alan.
Thanks in advance.

( v 4.393 )

I am assuming you are using the advanced servo card.

The card is a 1061_1 AdvancedServo 8 card

The setting for max slew rate was set up to set speed for older Phidget Servo card. Doesn't do a whole lot now. I have added ability to set Acceleration and Velocity for the Advanced Servo. Have not tested against servo because it's -2C degrees in my garage right now. Send me a PM with your email and I will send you an updated version.

Regards,
Alan

Hi Alan,

PM has been sent.

Regards,
Gerard