TILLER CONTROL and INTERFACE
Hi Folks.
Does anybody know how to interface a tiller arm with FS? I could use a potentiometer, but don't know how to connect to the system to make it 'talk' to FS? I have a Leo Bodner BU 0836X board and wondered if it could be used to do this?
Any help would be much appreciated.
TONY U.K.
'Twin Otter'
Re: TILLER CONTROL and INTERFACE
hi tony.........
connect the pot to the BU0836X card and if you have a registered version of FSUIPC, Peter has included in the axis options, a 'Steering Tiller'.
if you do not have a registered FSUIPC, then assign the axis to the rudder.
then you can spend all day driving round your favourite airport :o i did.
good luck and regards from wales ... ian
Re: TILLER CONTROL and INTERFACE
Quote:
Originally Posted by
ian@737ng.co.uk
hi tony.........
connect the pot to the BU0836X card and if you have a registered version of FSUIPC, Peter has included in the axis options, a 'Steering Tiller'.
if you do not have a registered FSUIPC, then assign the axis to the rudder.
then you can spend all day driving round your favourite airport :o i did.
good luck and regards from wales ... ian
YOU DEVIL YOU!! My airport is tiny - but I could always go into town!!!