triplehead2go

hello everyone , got a glitch number 139, i just set up three of my moniters and of course they are all diferent ones but i have used these same moniters before with th32g0.

the monitor on the right seems to be dark even though the briteness is all the way up.

when at night you cannot see the plane at all.

i thought it was the moniter and i swithed it out with another monitor and i got the same dark screen.
the left is good and the center is good.
ive downloaded the lastest drivers and such and im wondering if im missing anything.

when i set the time in the sim to daylight i can see the plane just fine but it still has a dark look to it, but at night i cannot see a thing.

any clues good folks.

thanks...........Robert

Do you have the analog or digital version?

Are you using LCD or CRT monitors?

im using three crt monitors , as i said before they are three differants and i have used them before.

will be getting flat screens in about three months but now its crts.

as i said i swithed them out and i get the same somewhat dark screen.

and for now im running xp-32

Thanks.........Robert

Did you also switch the cables when switching monitors? If not, try it.

Have you recently upgraded your video card's drivers? If so, try rolling them back and see if that helps.

Make sure the TH2Go works fine in the dual monitor mode and see if you get the same problem in the triple monitor mode with different resolutions.

Failing that, it might be a hardware problem with TH2Go.

Try www.widescreengamingforum.com/forum/ there are a lot of techy's over there.

Good luck!

Quote:

---

Originally Posted by Mr. Midnight

hello everyone , got a glitch number 139, i just set up three of my moniters and of course they are all diferent ones but i have used these same moniters before with th32g0.

the monitor on the right seems to be dark even though the briteness is all the way up.

when at night you cannot see the plane at all.

i thought it was the moniter and i swithed it out with another monitor and i got the same dark screen.
the left is good and the center is good.
ive downloaded the lastest drivers and such and im wondering if im missing anything.

when i set the time in the sim to daylight i can see the plane just fine but it still has a dark look to it, but at night i cannot see a thing.

any clues good folks.

thanks...........Robert

---

Hi Robert

Are you using the Triplehead2go digital or analogue version ?

Also are you connecting via VGA or DVI ?

Are you using VGA to DVI Converters ?

Regards


Lufty

Do check that monitor cable. I found a bad one on my utility system last week. I thought the mother board had failed on my new system because I had never had a bad monitor cable until now.

They do go bad occasionally.