eicas monitor panel for MIP
Hi
i would be very grateful for any help on this subject
i am making my own mip which will consist of 3 panels,PFD L/H,EICAS AND PFD R/H
my question is as follows -i will be using a 19 inch monitor behind the PFD L/H AND R/H
but in the midle eicas panel i will be using 3 real standby guages (737)you know down the l/h side
of this panel which means i cant use a 17 inch monitor but one much smaller as just above it will be the flap
guage -has any one encountered this as i have looked on ebay and other sites for a small monitor to fit
but they all seem to be either too small or too large -basically has any one built a mip using real standby guages -if so could you please tell me what type of monitor was used for the midle of the MIP
many thanks
dave
Re: eicas monitor panel for MIP
Like a square 15" monitor?
Re: eicas monitor panel for MIP
Hi efe
15 inches would be too wide I have 9.5 inches from the
Back of the real gauges on the left to the back of the flap lever on the right
The 9.5 inches would have to be the total width of the monitor
I wouldn't have to worry about the length as it would be hidden at the bottom of the centre of my mip frame
Thanks for your reply
And have a good day
Dave
Re: eicas monitor panel for MIP
Dave
A 12 inch 4/3 ratio screen would fit. I got one off ebay with a screen size of 7.5" x 9.5" and an overall frame size of 13" x 9" No known make and ex POS equipmnet, but should give you a guide.
David
Re: eicas monitor panel for MIP
Many thanks for that fordgt40
I will have a look on eBay tonight
Cheers
Dave
Re: eicas monitor panel for MIP
simparts.de might have something. Also look into digital picture frames. Some of them has video in...
Re: eicas monitor panel for MIP
Well that's tight. 15 inch square monitors have a 10.6 inch edge measurement so I thought that might work. Apparently not for your case. So a smaller monitor is in order.
Re: eicas monitor panel for MIP
Thank you I will look at sim parts de
Re: eicas monitor panel for MIP
Many thanks flying fox this looks like the way to go
Thank you
Dave
Re: eicas monitor panel for MIP
No problem efe it looks like flying fox
Has solved my problem
Thanks for trying
Cheers
Dave