..........
Printable View
..........
which I/O Card are you useing? I use the FDS SYS-3 and in order for me to have lights turned on/off use Set Bit and Clear Bit. the bit beignt the one corresponding with the light i am programing. If your useing the FDS software i can walk you through it.
Hi,Quote:
Originally Posted by tunatuk
No matter what interface system you are using: this means that each bit represents a switch. If you set the bit to 0, switch will be off; if you set the bit to 1 the switch will be on.
It depends on the capabilities of your interface card hw and sw how you can do that.
But be aware: not every aircraft add-on supports (all) these bits...
Nico
I am going to be using a KE72 keyboard encoder, and am using different keypresses to act as the actuator in FSUIPC. What I am not understanding is the parameter for offset 0d0c, as it pertains to turning on and off lights. I see that there are different bits to write to, but what is the order to put things in?
Would an example be offset=0d0c parameter=11 for turning off the beacon lights?
How would the parameter be input and what offset byte xxxx would I use? there are lots to choose from!
..........
No, 2^0 = 1 ....!Quote:
Originally Posted by tunatuk
So you are using mask 1 to get bit 0 (the least significant bit in the offset).
The others are ok.
Nico