Hi
My default fsx 737 trim is way over to the right and nothing seems to centre it. Any suggestions would be appreciated
Mac
Printable View
Hi
My default fsx 737 trim is way over to the right and nothing seems to centre it. Any suggestions would be appreciated
Mac
Just checking, but did you try Numberpad 5?
That was quick off the mark Trev. I'll try that. Many thanks
No Problem. I can't remember if NumLock needs to be on of off. But if your views change when you press the numpad 5, then change the state of your NumLock key. LOL
Num 5 centres it for about 20 secs and then it flips back...............
I bet you have a UNWANTED joystick button commanding the trim....check through all your controller buttons in FSXQuote:
Num 5 centres it for about 20 secs and then it flips back.............
Nat
Thanks for that......disconnecting my yoke solves the problem. Of course I will need the yoke however.........I have a nose down/up trim switch and that shows the + and - changes in the EICAS but does nothing to sort the problem. Do I need to configure the trim switch and if so how?
Regards
Mac