Re: Problem with PM Sounds

Enrico,

I've switched PMSounds to my FS computer instead of my non-FS one. However,

if I load PMSounds with WideFS running and the FMC loaded on the non-FS PC I

get 'Run-time error 6 - overflow'. If I launch it without the FMC running it

loads fine.

Cheers,

"Ray Proudfoot" wrote in message
news:390225.77894@wb.onvix.com...
> Enrico,
>
> Have you any idea why I would get these multiple 'FMC detected' messages?
> Could it be related to other software talking to FS via WideFS?
>
> Thanks.
>
>
> "Enrico Schiratti" wrote in message
> news:389217.77894@wb.onvix.com...
>>> Question. Why is it reporting 2 sound devices found? Is that part of
the
>>> problem? I have a soundcard on my non-FS PC (the one running PMSounds)
>> and
>>> one on the FS9 PC.
>>
>> It just reports what the system tells it... I have three sound devices
>> reported on one PC where there is just one. This was because of an
> earlier
>> request by someone else.
>>
>> Ciao
>>
>> Enrico
>>
>>
>> "Ray Proudfoot" wrote in message
>> news:388640.77894@wb.onvix.com...
>>> I'm having problems with PMSounds v1.0.0.55. This is a sample of the
> data
>>> building up in the PM Sounds window...
>>>
>>> FMC Detected
>>> NetDir set to \\RAYPROUDFOOT\netdir\
>>> FMC Detected
>>> FMC Detected
>>> FMC Detected
>>> FMC Detected
>>> FMC Detected
>>> APU loop activated
>>> FMC Detected
>>> Speedbrake loop activated
>>> [error] Could not set Sound Device 2
>>> 2 Sound Devices Found
>>>
>>>
>>> The FMC Detected message is constantly repeated and within a minute of
>>> starting PM Sounds I lose the WideFS link to FS.
>>>
>>> Question. Why is it reporting 2 sound devices found? Is that part of
the
>>> problem? I have a soundcard on my non-FS PC (the one running PMSounds)
>> and
>>> one on the FS9 PC.
>>>
>>> After closing PM Sounds WideFs recovers and behaves normally.
>>>
>>> --
>>> Regards,
>>>
>>> Ray
>>> Cheshire, England
>>>
>>
>